How do waterproofing systems work in the basement and what exactly are they? Let’s take a look at the time and tested waterproofing of basement and how it works.
If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens:
A big hole in the ground is dug, the footer or foundations are laid, the walls of the basement are built and then the rest of the house follows.
That big hole in the ground, the first on the list above is important to note. The construction of basement walls invariably leaves a void on the exterior which requires backfilling. Loose backfill is what is used to fill this void. The problem here is that water looks for the path of least resistance, and you’ve just given it just that with a huge pile of loose backfill, no matter how well it’s been compacted.
This area is going to have water constantly seeping into it. Sometimes, creating a problem is the drainpipe that gets full of silt contained in most basement waterproofing systems. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. Allowing these pipes to fill up, can result in an overload of the system, which can be catastrophic to the basement’s outside walls. If there are crevices in the walls, water will push through even if the basement walls are waterproofed.
This type of problem doesn’t usually go away because the pipes that are supposed to take away the excess water gradually worsen over time.
A lot of the time a huge mistake is made by not providing access to these pipes. To keep water out of a basement, waterproofing is also applied to the external walls. This is often referred to as a tanked system.
If you want to find out if you have water inside the concrete block of your walls simply tap a hole into the concrete block, near the floor, and see if you have water coming out of this block then you may want to consider a drained cavity waterproofing system this system drains the water from your walls, much the same way you just did, by adding drain holes in the bottom blocks that allows those areas to drain into a type of interior french drain system. To protect the property water is controlled, collected and then made to pass through hidden drainage channels which are either natural drainage or sump pumps.
Basement waterproofing systems are superior because they are installed internaly, have easy access ports for removing silt, and can be installed in basements where other methods have failed.
In conclusion, you want a basement waterproofing system that will deliver:
- a permanent or long term fix
-stop water through the floor and walls
- not disturb landscaping, decks, patios, driveways, etc
- usually be an approved waterproofing method for home loans
-more affordable than other methods
Choose a reputable basement waterproofer when protecting your home, remember it is economically foolish not to waterproof, because the increased value from waterproofing will definitely exceed the cost of the waterproofing.
Waterproofing your home is an investment in its value.
Make it easier to start using basement waterproofing systems, quickly & easily. If you wish the the basics and ensure that you have a hassle free and cheap experience, visit , a website describing the plus and minus points of a water proofing system.